Support for yourWasher Dryer
All articles for Washer Dryer support
- < 25 % when drum empty
- < 25 % when drum full
- -0- on the display
- 888 on the display
- ADD on the display
- Anti-crease/Check detergent
- Anti-crease/Finish indicator light flashes and Locked comes on
- Call Service
- CapDosing
- Check detergent
- Check inlet indicator light flashes
- Check load after end of programme
- Check load programme cancelled
- Ctrl on the display
- Dashes - - - on display and indicator lights flash
- Display dark/no display
- Display has stripes/streaks
- Display has white dots/streaks
- Display inoperative after end of programme
- Display texts in another language
- Door locked
- Drain indicator light flashes
- Drain/spin does not start
- Enter PIN code
- Exclamation mark and Technical fault flashing
- Extra dry missing after update
- Fabric conditioner left in compartment
- Fault F1
- Fault F2
- Fault F3
- Fault F4
- Fault F10
- Fault F11
- Fault F16
- Fault F19
- Fault F20 or Heating fault
- Fault F29
- Fault F37
- Fault F39
- Fault F41
- Fault F43
- Fault F44
- Fault F45
- Fault F47
- Fault F49
- Fault F50
- Fault F51
- Fault F53
- Fault F55
- Fault F56
- Fault F62
- Fault F63
- Fault F64
- Fault F65
- Fault F92
- Fault F93
- Fault F103
- Fault F104
- Fault F130
- Fault F138
- Fault F210
- Fault F220
- Fault F242
- Fault F398
- Foam during washing
- Functional faults due to fluff deposits
- Grey greasy particles left behind on laundry
- Grinding noises when drum rotates
- i Cannot be changed
- Kettle noises during PowerWash 2.0
- Laundry has brown stains
- Laundry has grey stains
- Laundry has white residues
- Laundry is plastered against drum after spinning
- Laundry stiff after washing
- Laundry too damp after drying
- Laundry too damp/too dry after drying
- Laundry/washer-dryer smells unpleasant
- Leak between drain hose and drain pipe
- Leaking access panel
- Leaking detergent drawer
- Leaking door
- Leaking screwed connection at water inlet hose
- Limescale deposits in drum
- Liquid detergent not getting laundry clean
- Locked
- Locked indicator light comes on
- Locked. Enter code
- Maintenance wash does not remove odours
- Overload indicator light flashes
- Pillows spins before wash cycle
- Powder detergent left behind in detergent drawer
- Rinse out fluff time left display incorrect (WT1F Prestige)
- Slurping noises during draining
- Soak/Pre-wash, Wash, Rinse or Rinse Stop flashes
- Start does not light up
- Techn. fault, contact Service
- Time left display changes/stops
- Time left display keeps changing
- TwinDos cannot be used
- TwinDos cartridge is leaking
- TwinDos cartridges: changeover from film seal to caps
- TwinDos maintenance for compartment 1/compartment 2 must be started
- Update does not start
- Use “TwinDos” or carry out TwinDos maintenance in the “Maintenance” menu
- Use TwinDos or start maintenance
- Vibrations during spinning
- Washer-dryer drains frequently with PowerWash 2.0
- Washer-dryer inoperative
- Washer-dryer not spinning correctly
- Water drainage fault
- Water in capsule at end of programme
- Water inlet fault
- Water inlet fault during initial commissioning
- Waterproof system activated
- Why is it not possible to set a temperature in the Eco 40–60 programme?
- WoollensDrying mode time left display incorrect (WT1F Prestige)
- Zero setting not possible
Operating Instructions finder
Here you will find the operating instructions for your Miele appliances
Find your manual
