Support for yourWasher Dryer
Display messages & Indicator lights articles for Washer Dryer support
- < 25 % when drum empty
- < 25 % when drum full
- -0- on the display
- 888 on the display
- ADD on the display
- Anti-crease/Check detergent
- Anti-crease/Finish indicator light flashes and Locked comes on
- Call Service
- Check detergent
- Check inlet indicator light flashes
- Check load after end of programme
- Check load programme cancelled
- Ctrl on the display
- Dashes - - - on display and indicator lights flash
- Display texts in another language
- Drain indicator light flashes
- Enter PIN code
- Exclamation mark and Technical fault flashing
- Fault F1
- Fault F2
- Fault F3
- Fault F4
- Fault F10
- Fault F11
- Fault F16
- Fault F19
- Fault F20 or Heating fault
- Fault F29
- Fault F37
- Fault F39
- Fault F41
- Fault F43
- Fault F44
- Fault F45
- Fault F47
- Fault F49
- Fault F50
- Fault F51
- Fault F53
- Fault F55
- Fault F56
- Fault F62
- Fault F63
- Fault F64
- Fault F65
- Fault F92
- Fault F93
- Fault F103
- Fault F104
- Fault F130
- Fault F138
- Fault F210
- Fault F220
- Fault F242
- Fault F398
- i Cannot be changed
- Locked
- Locked indicator light comes on
- Locked. Enter code
- Overload indicator light flashes
- Soak/Pre-wash, Wash, Rinse or Rinse Stop flashes
- Start does not light up
- Techn. fault, contact Service
- TwinDos maintenance for compartment 1/compartment 2 must be started
- Use “TwinDos” or carry out TwinDos maintenance in the “Maintenance” menu
- Use TwinDos or start maintenance
- Water drainage fault
- Water inlet fault
- Water inlet fault during initial commissioning
- Waterproof system activated
- Zero setting not possible
Operating Instructions finder
Here you will find the operating instructions for your Miele appliances
Find your manual