The stopcock is not open.
Open the stopcock.
The dishwasher display shows fault F15. The water inlet is blocked or restricted.
Open the stopcock.
Clean the inlet filter:
Switch the dishwasher off.
Disconnect the dishwasher power plug.
Close the stopcock.
Unscrew the water intake valve.
Remove the seal from the screw connection.
Using combination or pointed pliers, take hold of the plastic filter bar and remove the plastic filter.
Rinse the plastic filter under running water.
Re-insert the plastic filter and the seal into the screw connection of the water intake valve. Ensure that the plastic filter and the seal are seated correctly.
Remove any kinks or loops from the water inlet hose.
Keep an eye on these points for a while afterwards, as the plastic may weaken and the material may tear. In the event of any damage, the water inlet hose must be replaced.
If this is necessary, contact the Miele Customer Service Department.
Contact the facility manager or a plumber.
If the fault persists, please contact us or book a repair appointment online.